Table of Contents
Advertisement
To install your new graphics card:
1. Locate the AGP slot. If necessary, remove
the metal cover from this slot; then align your
graphics card with the AGP slot, and press it
in firmly until the card is fully seated.
* Please make sure that the gold edge connectors of the graphics card is securely inserted.
2. Replace the screws to fasten the card in
place, and replace the computer cover.
3. Plug the display cable into your card; then
turn on the computer and monitor. If your
graphics card came with a DVI-I connector,
you can connect a flat panel display to the
appropriate connector, as shown below...
To TV / VCR
To VGA Monitor
You are now ready to proceed with the installation of the graphics card driver. Please refer
to next chapter for detailed instructions.
After installation, please connect the power cable to your graphics
card, or the system will not boot.
To Flat Panel Display
- 7 -
Hardware Installation
Advertisement
Table of Contents
