Yamaha MOTIF6 Voice Editor Manual page 18

2 SLOPE ............................Determines the slope or ramp characteristics of the LFO wave.
• OFF .............................No slope; the LFO instantly jumps to the level of each step.
• UP ...............................The LFO ramps up to the next step, when that step is higher in
• DOWN.........................The LFO ramps down to the next step, when that step is lower in
• UP & DOWN................The LFO ramps both up and down to the level of each step.
3 TEMPLATE......................You can select a pre-programmed template for the LFO wave.
• random........................Randomly generates step values, creating each time a different
• all0 ..............................Values of all the steps are set to 0.
• all64 ............................Values of all the steps are set to 64.
• all127 ..........................Values of all the steps are set to 127.
• saw up ........................Creates a saw shaped upward wave.
• saw down....................Creates a saw shaped downward wave.
• even step ....................Values of all even steps are set to 127, and values of all odd steps
• odd step......................Values of all odd steps are set to 127, and values of all even steps
4 Wave graph.....................Click on the text box and select the method of restarting the LFO
5 RESET.............................Values of all the steps are reset to 0.
6 VALUE .............................Edit the value for each step by using the corresponding knob.
CONTROLLER (Plug-in Voice only)
This determines the depth of pitch, cutoff, pitch modulation, cutoff modulation, and amplitude
modulation.
8 ELEMENT unit
This section is explained in more detail in "Element Unit"
9 INSERTION EFFECT units
This section is explained in more detail in "Insertion Effect"
) SYSTEM EFFECT settings
This section is explained in more detail in "System Effects"
! Keyboard
Click any key on the keyboard to monitor your edited voice in that key.
@ KEY ASSIGN settings
Click on the left text box to select a Key Assign setting. Click on the right text box to select
Monophonic or Polyphonic. The "KEY ASSIGN" settings are not available for Drum Voices.
# MICRO TUNE settings
Click on the text box to select a Micro Tuning preset.
The "MICRO TUNE" settings are not available for Drum Voices.
value. No slope for lower steps.
value. No slope for higher steps.
The selected template's wave graph appears in the dialog.
random LFO wave.
are set to 0.
are set to 0.
when a note is played.
18
(page 20).
(page 25).
(page 25).