Table of Contents
Advertisement
INSTALLATION
ENVIRONMENT
Leave some space
Space at last 15cm between the washer
and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2˚)
Never install the washer near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose about
70~80cm above the ground
for pump model.
CLEANING THE MACHINE
CLEANING THE LINT FILTER
If the dregs are filled up in the lint filter after
finishing the wash, push down and pull it
out as shown in figure.
Remove the collected lint and rinse the filter net.
1
2
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush.
Painted surfaces or plastic parts will be damaged.
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter
not to wet the floor.
2. Rotate the filter counterclockwise
and pull out the filter.
3. Remove dirts and rotate
the filter clockwise until it
locks in position.
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
a
b
OVERFLOW FILTER
Pull the upper side of the overflow filter
with two fingers into the hole 'A'
in the direction of arrow as
shown in the figure.
5
(In case drain pump)
A
Advertisement
Table of Contents
