Table of Contents
Advertisement
INSTALLATION
E NV IR ONME NT
L eave s ome s pace
S pace at last 15cm between the washer
and the wall.
P lace the was her on a s turdy flat s urface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2û )
Never ins tall the was her near water.
Do not place the washer in steamy rooms or
where the washer is directly exposed to rain.
Moisture may destroy the electrical insulation
and cause an electrical shock hazard.
Avoid direct s unlight or heating devices .
As plastic and electrical components are
affected by direct heat, never place the
washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose about
70~80cm above the ground
for pump model.
CLEANING THE MACHINE
1. OV E R F L OW F ILT E R
P ull the upper side of the
overflow filter with
your fingers into the holes
in the direction of arrow as
shown in the figure.
3. C L E A NING T HE WA S HE R B ODY
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene,thinners,cleanser,or wax, nor scrub the washer with a brush.
P ainted surfaces or plastic parts will be damaged.
HOW TO CLE AN THE FILTE R
1. P lace a rag under the washer filter
not to wet the floor.
2. R otate the filter counterclockwise
and pull out the filter.
3. R emove dirts and rotate
the filter clockwise until it
locks in position.
C ONNE C T ING T HE DR A IN HOS E
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
a
b
2. C L E A NING T HE F ILT E R
P ush the strainer(filter) out and take up the
filter as shown in figure.
Wash the filter and washing tub.
5
(In case drain pump)
Advertisement
Table of Contents
