Table of Contents
Advertisement
CLEANING THE FILTER NET
1. Push the upper part of
the filter and pull in.
LEVELLING
Adjust a waterdrop mark to be in the red
line at the center of the level meter.
G
Open the lid of the machine, and check if
it is levelled properly in the same way of the
picture.
G
There can be a few
differences according to
the models.
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in
position.
HOW TO PUT THE DETERGENT/RINSE IN
Pull the detergent/rinse box.
Put the detergent as much as the diagram deside
water level indicator, and fill the fiber softner up to
the baseline.
CAUTION : When to much softner is stored above the
base line,it may flow down at any time.
2. Open the cover as
shown in the figure.
Levelling is complete
Level meter
3. Clean the filter.
4. Close the cover and insert the lower
part of the filter in the basket first and
then push the filter with "click" sound .
Adjustment the heigt of the machine
Adjust the legs to level the washer
Be careful not to put in your hand under the legs.
Detergent Device
Put the detergent
in proportion to
water level
Pull the handles located at the
right and left of the front side
and slide off.
Adjust the height of the machine
upward or downward.
When the adjustment
is finished, push the handles
to fix the adjusting legs.
Softner Device
Softner
baseline
Softner Device
Softner
baseline
8
Advertisement
Table of Contents
