Table of Contents
Advertisement
INSTALLATION & MAINTENANCE
ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs. (Allowable is 1°)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where
the washer is directly exposed to rain.Moisture may
destroy the electrical insulation causing an electrical
shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat,never place the washer near furnaces,
boilers,etc.Do not place under direct sunlight.
IN CASE OF PUMP DRAINED WASHER
G
G
Take out the
Be sure to join tightly
cap-hose and
the drain hose into the
connect the
drain-outlet on theback
outlet-hose.
of the machine.
cap-hose
outlet-hose
CONNECTING THE WATER SUPPLY HOSE
1. Remove the adaptor from
the water supply hose.
2. First,using a "+" type screw
driver, loosen the four
screws on the adaptor.
Next,take the adaptor and
turn part(b) following the
arrow for gap about 5mm
between them.
3. Connect adaptor to the
water tap by tightening the
screws firmly.
Then,turn part (b) following
the arrow and put (a) and
(b)together.
NOTICE
After completing connection,if water leaks from the hose,then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.
7
ASSEMBLING METHOD OF ANTI-
RAT COVER
Push front side of Anti-rat cover into
assembling inlet
G
Take off Anti-rat cover, which is
adhered to the rear of the product,
and then assemble it.
G
Install the cover to reduce noise
and prevent any mouse from
entering the system.
When you feel difficult in assembling, take
following action
G
While raising front side of washing
machine upward a little, push Anti-
rat cover forward with your hand in
line with insertion groove. you can
do it easily.
(After finishing the insertion work,
G
Install the drain hose
make sure that fixed area at the middle has been firmly
in the position of
inserted.)
about 70~80cm
above the ground.
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
(a)
1
(b)
4. Connect the water supply hose
to the adaptor. Pull down the
part (c) of the water supply
hose .When the part (c)is
released,the hose is automat-
ically connected to the adaptor
making a 'click' sound.
5. Connect the other end of
the water supply hose to the
inlet water valve at the back
of the washer.
Screw the hose clockwise
all the way in.
If the water tap is a screw
type,assemble a water
supply hose that fits to the
tap as shown.
Anti-rat cover
Advertisement
Table of Contents
