Connecting The Water Supply Hose (Option) - Samsung Q1457AT Owner's Instructions Manual

Installing the Washing Machine

Connecting the water supply hose (Option)

1. Remove the adaptor from the
water supply hose.
2. First, using a '+' type screw driver,
loosen the four screws on the adaptor.
Next, take the adaptor and turn
part(b) following the arrow until there
is a 5mm gap.
3. Connect adaptor to the water tap
by tightening the screws firmly.
Then, turn part (b) following the
arrow and put(a) and (b) together.
NOTICE After completing connection, if water leaks from the hose, then repeat the same steps. Use
the most conventional type of faucet for water supply. In case the faucet is square or too
big, remove the spacing ring before inserting the faucet into the adaptor.
Positioning the drain hose
The end of the drain hose may be positioned in three ways:
Over the edge of a wash basin
The drain hose must be placed at a height of
between 60 and 90 cm. To keep the drain hose
spout bent, use the supplied plastic hose guide.
Secure the guide to the wall with a hook or to
the faucet with a piece of string to prevent the
drain hose from moving.
ln a sink drain pipe branch
The drain pipe branch must be above the sink siphon so that the end of the hose is at least
60 cm above the ground.
ln a drain pipe
Samsung recommends that you use a 65 cm high vertical pipe; it must be no shorter than 60 cm
and no longer than 90 cm.
c
a
b
SAMSUNG Washing Machine Owner's Instructions 5
4. Connect the water supply hose to
the adaptor. Pull down part (c) of the
water supply hose.
When you release part (c) the hose
automatically connects to the adaptor
making a 'click' sound.
5. Connect the other end of the water
supply hose to the inlet water valve at
the rear of the washer.
Screw the hose clockwise all the way
in