Table of Contents
Advertisement
WM stops the current step of the cycle or does not proceed to the next
step of washing (indication of remain time on LED display may increase).
Your new washing machine is equipped with Fuzzy Logic system, which not only sets the optimum level of
water and other parameters of washing, but also controls the washing process as well as makes necessary
corrections in order to provide better washing results. In the above- mentioned matter, the Fuzzy Logic system
has detected deviations in washing cycle such as: high quantity of detergent at the end of the cycle, high
vibration level while spinning, etc.You can adjust existing wash programs, i.e. change wash temperature and
spin speed. After detection of such abnormalities, the washing machine is suspending the normal course of
program in order to normalize these parameters and continue the cycle. Fuzzy Logic system makes 7
attempts to eliminate such deviations. If it is impossible to normalize the above mentioned deviations by Fuzzy
Logic system, you will see the corresponding indication on LED lamps. (see chapter "Troubleshooting") The
operation of Washing machine that corresponds to above- mentioned scheme is considered to be normal.
Washing for the first time
Before washing clothes for the first time, you must run a complete cycle without clothes. To do this:
1. Press the
(On/Off) button.
2. Pour a little detergent in the detergent drawer
3. Turn on the water supply to the washing machine.
4. Press the Temperature button repeatedly until 40˚C is dis-
played.
5. Press the Start/Pause button.
•
This will remove any water from the manufacturer's test run
remaining in the machine.
Putting detergent in the washing machine:
1. Pull out the detergent drawer.
2. Add laundry detergent into compartment
3. Add softener into compartment
Caution:1) Concen trated or thick fabric softener and conditioner must be diluted with a little water before
bein gpoured into the dispenser.(prevents the overflow from becoming locked)
2) You must forbid puttg detergent to the compertement
block up.
4. Add prewash detergent into compartment
* Option
Using Hot Water
• The hot water valve is operated when you select a water temperature option above 60(C (60(C or 95(C)
* Silver Nano
• If it is used together with fiber softener, it's effect may be decreased.
For the silver nano washing
The Ag+ water is added during the washing and than a sanitary, sterilizing washing will be performed during
the rinse, the Ag+ water is added at the last time of rinse, It treats cloths with silver antibiotic coating and
functions to protect the propagation of bacteria.
1. Open the door, put in the clothes and close the door again.
2. Press power button.
3. Select a course by turning the course selection dial.
4. Press silver nano button.
5. Put suitable amount of detergent and fiber softener in the detergent tray and close it again. Put a suitable
amount of detergent on the detergent tray for main washing and put in fiber softener to the lower lever
than the marbled line in the detergent tray
6. Press start/hold button:It automatically performs an optimal washing with sensing the weight of clothes.
Washing a Load of Laundry
.
(if you desire).
(if you desire).
.
because detergent mabe the hole
6
Advertisement
Table of Contents
