Related Manuals for Samsung VAC-7713SP
Summary of Contents for Samsung VAC-7713SP
-
Page 1: Vacuum Cleaner
DJ68-00079M(US) 7/28/01 2:06 PM Page 1 Operating lnstructions Models VAC-7700 SERIES For household use only VACUUM CLEANER Before operating this unit, please read the instructions carefully. -
Page 2: Important Safety Instructions
DJ68-00079M(US) 7/28/01 2:06 PM Page 2 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following : READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER WARNING To reduce the risk of fire, electric shock, or injury. 1. - Page 3 DJ68-00079M(US) 7/28/01 2:06 PM Page 3 17. Do not use extension cords or an outlet with inadequate current carrying capacity. 18. Hold plug when rewinding onto cord reel. Do not allow plug to whip when rewind- ing. 19. Unplug electrical appliances before vacuuming them. 20.
-
Page 4: Parts Identification
DJ68-00079M(US) 7/28/01 2:06 PM Page 4 PARTS IDENTIFICATION DUST-FULL INDICATOR If the “Dust-Full” indicator switches to “RED” while you are cleaning, the dust bag is full and must be replaced. NOTE : If the “Dust-Full” indicator continues to display “RED” even after changing the dust bag, turn the cleaner off and check whether the hose, tube or noz- zle is clogged. - Page 5 DJ68-00079M(US) 7/28/01 2:06 PM Page 5 ASSEMBLING THE VACUUM CLEANER FOR USE Attaching the Hose to the Canister Slide the Hose Clamper into the Canister lnlet until it “clicks” into place.(Fig. A-A) Assembling the Extension Wand Slide the narrow end of one Extension Wand section into the other Wand Extension.(Fig.
-
Page 6: On/Off Switch
DJ68-00079M(US) 7/28/01 2:06 PM Page 6 POWER CORD 1) PULLING OUT The power cord is long enough to be drawn out for convenience. 2) REWINDING Upon finishing cleaning, disconnect the plug from the electri cal outlet and press the cord rewind button lightly with your toe. -
Page 7: Park Position
DJ68-00079M(US) 7/28/01 2:06 PM Page 7 OPERATING THE BRUSH HEAD Push the ON/OFF switch(A) down. (The brush switches on) PARK POSITION Located in the top rear side of the vacuum cleaner, there is a support for a convenient park position during pauses when using the nozzle. -
Page 8: Maintenance Or Replacement Of The Filters
DJ68-00079M(US) 7/28/01 2:06 PM Page 8 3) After removing the used dust bag, insert 4) Press the dust cover down gently the cardboard bag collar of the new dust until the clamp relocks. bag into the suction inlet all the way. NOTE : Used dust bag can be sealed by remov- ing the film from the paper and sticking... -
Page 9: Maintaining The Power Brush
DJ68-00079M(US) 7/28/01 2:06 PM Page 9 CAUTION: Do not invert the power brush while it is running 3. Checking the Performance of the Power Brush You may check whether the power brush is operating correctly by lifting up the extension tube slightly to view the back of the brush. The Power Brush will not operate when it is jammed or the unit is turned off. - Page 10 DJ68-00079M(US) 7/28/01 2:06 PM Page 10 1) Remove the brush cover, Grasp the 2) Remove the flat belt from the motor brushroller firmly, and pull it out. shaft and the brushroller, Loop the new belt around the motor shaft and then loop it around the brushroller.
-
Page 11: Troubleshooting
DJ68-00079M(US) 7/28/01 2:06 PM Page 11 TROUBLESHOOTING PROBLEM CAUSE REMEDY Motor does not start No voltage Check cable, plug and socket. Suction force is Filter,nozzle,suction Remove the obstruction or gradually reduced hose tube blocked, or replace bag. bag full. Cord does not rewind Check that the cord is Pull the cord out 6~10ft &... - Page 12 DJ68-00079M(US) 7/28/01 2:06 PM Page 12 DJ68-00079M REV(0.0)