Table of Contents
Advertisement
BN68-448D-03Eng
11/11/03 2:43 AM
Setting Up Your Remote Control
English-60
Page 60
Setting Up the Remote to Operate Your DVD
1
Turn off your DVD.
2
Press the SELECT button and make sure that the DVD LED is
illuminated.
3
Press the SET button on your TV's remote control.
4
Using the number buttons on your remote control, enter three digits
of the DVD code listed on page 61 of this manual for your brand of
DVD. Make sure you enter three digits of the code, even if the first
digit is a "0".
If there is more than one code listed, try the first one.
5
Press the Power button on the remote control.
Your DVD should turn on if your remote is set up correctly.
If your DVD does not turn on after set up, repeat steps 2, 3, and 4,
but try one of the other codes listed for your brand of DVD.
If no other codes are list-ed, try each code, 000 through 008.
Note on Using Remote Control Modes: DVD
When your remote control is in "DVD" mode, the volume buttons
still control your TV's volume.
Advertisement
Table of Contents
