Table of Contents
Advertisement
BN68-00448G-00Eng.q
9/24/03 6:25 PM
Setting Up Your Remote Control
After it has been set up properly, your remote control can operate in
four different modes: TV, VCR, Cable, or DVD. Pressing the
corresponding button on the remote control allows you to switch
between these modes, and control whichever piece of equipment you
choose.
Note
The remote control might not be compatible with all DVD Players,
VCRs and Cable boxes.
Setting Up the Remote to Operate Your VCR
1
Turn off your VCR.
2
Press the SELECT button and make sure that the VCR LED is
illuminated.
3
Press the SET button on your TV's remote control.
4
Using the number buttons on your remote control, enter three digits
of the VCR code listed on page 62 of this manual for your brand of
VCR. Make sure you enter three digits of the code, even if the first
digit is a "0".
(If more than one code is listed, try the first one.)
5
Press the Power button on the remote control.
Your VCR should turn on if your remote is set up correctly.
If your VCR does not turn on after set up, repeat steps 2, 3, and 4,
but try one of the other codes listed for your brand of VCR.
If no other codes are listed, try each VCR code, 000 through 089.
Note on Using Remote Control Modes: VCR
When your remote control is in "VCR" mode, the volume buttons
still control your TV's volume.
Page 59
POWER
TV
P.MODE
SELECT
1
2
3
4
5
6
7
8
9
-/--
PRE-CH
0
P
VIDEO
MUTE
ENTER
STILL
S.MODE
DUAL I-II SURROUND
BN59-00373
P.SIZE
SLEEP
PIP
DNIe
PC
SWAP
P
REW
STOP PLAY/PAUSE
FF
SET
RESET
BN59-00373A
English-59
Advertisement
Table of Contents
