Table of Contents
Advertisement
03-BN68-00349G-02Eng
8/21/03 3:09 PM
Setting Up Your Remote Control
Setting Up the Remote to Operate Your Cable Box
1
Turn off your cable box.
2
Press the MODE button and make sure that the Cable LED is
illuminated.
3
Press the SET button on your TV's remote control.
4
Using the number buttons on your remote control, enter three
digits of the cable box code listed on page 53 of this manual for
your brand of cable box. Make sure you enter three digits of the
code, even if the first digit is a "0."
If there is more than one code listed, try the first one.
5
Press the Power button on the remote control.
Your cable box should turn on if your remote is set up correctly.
If your cable box does not turn on after set up, repeat steps 2, 3,
and 4, but try one of the other codes listed for your brand of cable
box. If no other codes are listed, try each code, 000 through 077.
Note on Using Remote Control Modes: Cable Box
When your remote control is in "Cable Box" mode, the volume
buttons still control your TV's volume.
Page 51
English-51
Advertisement
Table of Contents
