Advertisement
• FINAL INSPECTION
1. Check all lines (hydraulic, vacuum, air
conditioning and fuel) to ensure there is
adequate clearance to T.E.S. components.
Note especially a/c lines on right side; secure
away from T.E.S.
2. Re-connect battery.
Large Alternator
Bracket
1-1/4" Header bolt
& lockwasher
Right Side Hardware Locations
Qty.
Description
❑ 1
Header left side #25-9313 (#66032)
❑ 1
Header right side #25-9314 (#66032)
❑ 1
Header left side #25-9090 (#66033)
❑ 1
Header right side #25-9091 (#66033)
❑ 1
Extension pipe right #25-9597
❑ 12
Hex header bolts; 3/8" - 16 x 1"
❑ 1
Hex header bolt; 3/8" - 16 x 1-1/4"
❑ 1
Hex header bolt; 3/8" - 16 x 2"
❑ 2
Chevrolet V8 port gaskets
❑ 1
Donut gasket; 2-1/4"
Catalog #66032, #66033
©2006 Edelbrock Corporation
2" Header bolt, 3/4"
spacer, lockwasher, and
hardened flat washer for
small alternator bracket
assembly
1" Header bolt &
lockwasher
Fig. 1
Catalog #66032 (Ceramic-Coated), #66033 (Ti-Tech Coated)
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: 1-800-416-8628
E-Mail: Edelbrock@Edelbrock.com
3. At this point it is a good idea to look everything over
and make sure that nothing was missed in
assembly.
4. Start vehicle and bring up to normal operating
temperature. Check for possible leaks.
5. Turn engine off and let cool. Tighten all bolts again.
Front
Modified Large Alternator Brace Installed (Arrow)
KIT CONTENTS
Qty.
❑ 1
❑ 3
❑ 3
❑ 2
❑ 1
❑ 3
❑ 17
❑ 4
❑ 1
Page 3 of 3
Fig. 2
Description
Catalytic converter gasket
Hex nuts; 3/8" - 16
Hex bolts; 3/8" - 16 x 1-1/2"
Hex bolts; 3/8" - 16 x 2"
Spacer tube; 5/8" O.D. x 3/4"
Flat washers; 3/8"
Lock washers; 3/8"
Hardened washers; 3/8" I.D. x 1/8"thick
Alternator bracket
Brochure #63-66032
Rev. 9/06 - DA/mc
Advertisement
