Advertisement
•
DISASSEMBLY
1. Disconnect negative cable from battery.
2. Use penetrating oil on all nuts and bolts to be
removed. This will prevent the possibility of
broken or stripped nuts and bolts.
3. Unbolt exhaust pipes from both exhaust
manifolds.
4. Unbolt and remove both exhaust manifolds.
5. Clean and inspect all sealing surfaces before
assembly.
•
ASSEMBLY - LEFT SIDE
1. With manifold port gasket in place, start a
header bolt with lock and flat washer in the
rearmost bolt hole leaving enough room for the
manifold to slip into position.
2. Start balance of header bolts with lock washers
and tighten evenly.
Qty.
Description
❑ 1
#25-9269 Header left side (#68452)
❑ 1
#25-9272 Header right side (#68452)
❑ 1
#25-9036 Header left side (#68453)
❑ 1
#25-9035 Header right side (#68453)
❑ 2
Manifold port gaskets
❑ 4
Flat washers; 3/8"
©2006 Edelbrock Corporation
Rev. 5/06 - DA/mc
INSTALLATION INSTRUCTIONS
HARDWARE SUPPLIED
Catalog #68452 (Ceramic-Coated), #68453 (Ti-Tech Coated)
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: (800) 416-8628
Office: (310) 781-2222
E-Mail: Edelbrock@Edelbrock.com
•
ASSEMBLY - RIGHT SIDE
1. With gasket in place, start all bolts except the
rear bolt with lock and flat washers on each.
2. Start rear bolt with A.I.R. tube support bracket in
place.
3. Tighten balance of header bolts evenly.
4. Re-attach exhaust pipes to TES manifolds using
your original nuts.
5. Connect all parts including battery.
6. Start engine and bring up to normal running
temperature, then turn off and let cool.
7. When cool, re-tighten all manifold nuts and bolts.
Qty. Description
❑ 16 Header bolts; 3/8"-16 x 1"
❑ 16 Lockwashers; 3/8"
❑ 1
A.I.R. tube support bracket
❑ 1
Hex nut; 1/4" - 20
❑ 1
Lockwasher; 1/4"
❑ 1
Hex cap screw; 1/4"-20 x 3/4"
Page 2 of 2
Catalog #68452, #68453
Brochure #63-68452
Advertisement
