Advertisement
DISASSEMBLY OF EXHAUST PIPES
1. Disconnect battery.
2. Raise vehicle and support with jackstands.
3. Use penetrating oil on all nuts and bolts to be removed.
4. Remove O2 sensors and unbolt exhaust pipes from
manifolds.
5. Unbolt from catalytic converter and remove assembly from
vehicle.
DISASSEMBLY LEFT SIDE
1. Remove spark plugs and wires.
2. Disconnect E.G.R. tube from manifold under car.
3. Remove plastic cover on lower steering shaft. Remove
bolt and slide shaft up and off steering box and push shaft
aside.
4. Disconnect temperature wire from cylinder head.
5. Unbolt and remove stock manifold from top side.
DISASSEMBLY RIGHT SIDE
1. Remove spark plugs and wires.
2. Unbolt dipstick bracket from cylinder head, do not remove
dipstick.
3. Unbolt and remove right side manifold from top side.
ASSEMBLY RIGHT SIDE
1. Start rear manifold bolt with gasket; lock and flat washers
in place, then screw in leaving enough space to accept
T.E.S. manifold. Note: Be sure spark plug clips do not
interfere with manifold surface.
2. Place manifold into vehicle with dipstick between first and
second primary tubes, slide manifold into position and
start all bolts using lock washers provided. (Lock and flat
washers on all slotted ends).
3. Re-attach dipstick to cylinder head using 1/4" bolt and
1/2" long spacer tube provided in kit.
4. Tighten all bolts at this time.
Catalog #s 67112, 67113, 67152, 67153
©2006 Edelbrock Corporation
INSTALLATION INSTRUCTIONS
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Tech Line: 1-800-416-8628
E-Mail: Edelbrock@Edelbrock.com
ASSEMBLY LEFT SIDE
1. Remove E.G.R. adapter in stock manifold and place it in
T.E.S.
2. Start rear manifold bolt with gasket, lock and flat washers
in place, and screw in leaving enough space to accept
T.E.S. manifold. Note: Be sure the spark plug clips do not
interfere with manifold surface.
3. Slide manifold into position and start all bolts using lock
and flat washers on all slotted ends. Do not tighten yet.
Use ferry bolt and spacer for radiator hose support
bracket, tighten header.
4. Re-attach E.G.R. hose to manifold.
5. Re-attach steering shaft to steering box and replace cover.
6. Re-connect temperature sensor wire.
7. Install spark plugs and wires.
8. Replace air cleaner assembly.
ASSEMBLY OF EXTENSION PIPES
1. Raise vehicle and install both sides of extension pipes
using both donut gaskets and catalytic converter gasket.
Left side extension pipe uses flange connector. All provided
in kit.
2. Once everything is lined up, tighten down all hardware on
collectors and catalytic converter.
3. Replace 02 sensors in the locations that give best
clearance to body, frame and transmission. Some wire
rerouting may be necessary.
4. Use 02 plug provided in kit to plug unused 02 sensor
position.
5. Re-connect battery and start car to bring up to normal
operating temperature and check for leaks.
6. Turn engine off and let cool. Tighten all bolts again.
®
Page 2 of 2
Brochure #63-67112
Rev. 5/06 - DA/mc
Advertisement
