Advertisement
ASSEMBLY
1. Install (a section) of header assembly from top side with gasket and 9 hardened washers (supplied in kit), using
factory bolts/nuts as applicable.
2. Install secondary section (B section) to (A section) top half using the three 10mm. Bolts and lock washers with
the two crush ring gaskets (all supplied in kit). Use anti-seize on threads. (The two crush rings should be installed
with the seam or split down towards B-section).
3. With donut in place, connect header to catalytic converter using stock hardware as before.
4. Install O2 sensor, if equipped. Use anti-seize on threads of sensor and torque to 30 ft. lbs.
Catalog #6652 (Polished)
Qty.
Part #
1
25-9180
1
25-9181
1
22-6852
Catalog #6752 (Unpolished)
Qty.
Part #
1
25-9182
1
25-9183
1
22-6852
Catalog #6852 (Ceramic-Coated)
Qty.
Part #
1
25-9178
1
25-9179
1
22-6852
©2002 Edelbrock Corporation
PARTS LIST
Description
Pro-Flo Header (A section)
Pro-Flo Header (B section)
Installation Kit
PARTS LIST
Description
Pro-Flo Header (A section)
Pro-Flo Header (B section)
Installation Kit
PARTS LIST
Description
Pro-Flo Header (A section)
Pro-Flo Header (B section)
Installation Kit
Edelbrock Corporation
2700 California Street
Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Office: (310) 781-2222
Tech E-Mail: edelbrock@edelbrock.com
Qty.
1
1
1
Qty.
1
1
1
Qty.
1
1
1
Page 2 of 2
PARTS LIST
Catalog #6653 (Polished)
Part #
Description
25-9180
Pro-Flo Header (A section)
25-9211
Pro-Flo Header (B section)
22-6852
Installation Kit
PARTS LIST
Catalog #6753 (Polished)
Part #
Description
25-9182
Pro-Flo Header (A section)
25-9210
Pro-Flo Header (B section)
22-6852
Installation Kit
PARTS LIST
Catalog #6853 (Polished)
Part #
Description
25-9178
Pro-Flo Header (A section)
25-9209
Pro-Flo Header (B section)
22-6852
Installation Kit
Catalog #6652, #6752, & #6852
Catalog #6653, #6753, & #6853
Rev. 8/02
Advertisement
