Various Mounting Methods - Kenwood KS-8200EX Instruction Manual

÷
The supplied speaker wires are color-coded according to
the speakers to be connected. See the description in
"Connections" for details.
7 Front speaker
1
Screw two screws on two vertically lined-up positions on
the wall by leaving a distance of 217 mm (8-9/16 inches)
between them. Screw each screw only part way in, so
that the screw projects 4 to 6 mm (3/16 to 1/4 inches)
outward from the wall surface.
2
Hang the speaker by fitting the two mount holes (at the
rear of the speaker) over the extending part of the screw.
Confirm that the speaker is held firmly and securely in place.
7 Center speaker
1
Screw two screws into the walls 217 mm (8-9/16 inches)
apart, making sure that screws are horizontally level. Screw
each screw only part way in, so that the screw projects 4
to 6 mm (3/16 to 1/4 inches) outward from the wall sur-
face.
2
Hang the speaker by fitting the two mount holes (at the
rear of the speaker) over the extending part of the screw.
Confirm that the speaker is held firmly and securely in place.
7 Surround speaker
1
Screw a single screw into the wall at the desired location.
Screw it only part way in, so that the screw projects 6 to
10 mm (1/4 to 3/8 inches) outward from the wall surface.
2
Hang the speaker by fitting the mount hole (at the rear of
the speaker) over the extending part of the screw. Confirm
that the speaker is held firmly and securely in place.
Precautions
Please observe the following precautions when mounting speakers onto the wall.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. front speaker: 1.8 kg
[3.9 lb],center speaker: 1.8 kg [3.9 lb], surround speaker: 0.8 kg [1.8 lb]).
• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and that
are long enough to provide sufficient strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this type of
installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.

Various mounting methods

7 On the optional kenwood stand (SR-8000)
The speaker can be installed on the SR-8000 stand optionally
available from KENWOOD.
7 On the commercially available speaker mount or
bracket
Any commercially available speaker mount or bracket can also
be used (provided that the speaker can be fixed using an M5
screw with a pitch of 60 mm and effective thread length of 10
to 13 mm).
For details, read the instruction manual for the speaker mount
or bracket.
217 mm
(8 - 9/16")
4 - 6 mm
(3/16 - 1/4")
217 mm
(8 - 9/16")
6 - 10 mm
(1/4 - 3/8")
E ffe c t i ve t h r e a d
length
M5 screw
Installation Methods
Front speaker
Center speaker
Remove the
two screws
7
EN