How Do I Operate Devices; Operating Devices In Zone A; Operating Devices In Zone B; Operation Using The Sys.power Button On Powertouch - Kenwood KRF-X9995D User Manual

How Do I Operate Devices?

How Do I Operate Devices?
General instructions for operating any device are given under "How Do I
Operate Devices?" on page 35. Some operations, however, are a little dif-
ferent depending on the zone you are in. The following section discusses
how devices may operate differently in different zones.

Operating Devices in Zone A

To select the speakers for Zone A, press the button for Speakers–A on the
front panel of the receiver.
To set up PowerTouch to control Zone A devices, follow the instructions
under "How Do I Switch Control Modes?" on page 91.
To control a second CD player from Zone A, use
using a Kenwood 200-Disc CD Changer (see below).
Kenwood DPF-J9030, DPF-J9020 or DPF-J9010 200-Disc CD Changers
are specifically designed to work with the KRF-X9995D in a dual-zone
environment. Since they contain two CD players, one can play in Zone A
while the other is playing simultaneously in Zone B. Use CD1 to control
the changer for Zone A and CD2 to control the changer for Zone B.

Operating Devices in Zone B

If you are using the receiver's Speaker B outputs to power the speakers in
Zone B, press the button for SPEAKERS B on the front panel of the re-
ceiver to activate the speakers in Zone B. The Listen Mode in Zone A will
automatically switch to stereo when you turn SPEAKERS B on.
To set up PowerTouch to control Zone B devices, follow the instructions
under "How Do I Switch Control Modes?" on page 91.

Operation using the SYS.POWER button on PowerTouch

To perform the Multi-Zone operation, switch the Multi Zone function on
in advance (see page 91).
1. When the receiver is OFF (STANDBY mode):
• To output the video and audio to Zone A, set the Zone setting of
the PowerTouch to Zone A then press the SYS.POWER button on
the PowerTouch.
• To output the video and audio to Zone B, set the Zone setting of
the PowerTouch to Zone B then press the SYS.POWER button on
the PowerTouch.
, unless you are
93