Before Applying The Power; Unpacking; Preparing The Remote Control - Kenwood KRF-X9070D Instruction Manual

Before applying the power

Unpacking

Unpack the unit carefully and make sure that all accessories are
present.
FM indoor antenna (1)
Remote control unit (1)
RC-R0821
If any accessories are missing, or if the unit is damaged or fails to operate,
notify your dealer immediately. If the unit was shipped to you directly,
notify your shipper immediately. Kenwood recommends that you retain
the original carton and packing materials in case you need to move or ship
the unit in the future.
Keep this manual handy for future reference.
Memory back up function
Please note that the following items will be deleted from the unit's
memory if the power cord is disconnected from the AC outlet for
approximately 1 day.
• Power mode.
• Input selector settings.
• Picture output.
• Speaker ON/OFF.
• Volume level.
• BASS, TREBLE, INPUT level.
• TONE ON/OFF.
• LOUDNESS ON/OFF.
• Dimmer level.
• MD/TAPE settings.
• Listen mode setting.
• Speaker settings.
• SURR:MIX ON/OFF
• SW RE-MIX ON/OFF.
• Distance setting.
4
EN
AM loop antenna (1)
Batteries (R6/AA) (2)
• Bass peak level.
• Display mode.
• Input mode setting.
• Midnight mode setting.
• PRO LOGIC II mode setting.
• CS II mode setting.
• Broadcast band.
• Frequency setting.
• Preset stations.
• Tuning mode.
• THX mode.
• DSP mode.
• ACTIVE EQ mode.
• SPEAKER EQ mode.

Preparing the remote control

Loading the batteries
1 Remove the cover.
3 Close the cover.
• Insert two AA-size (R6) batteries as indicated by the polarity markings.
Operation
When the STANDBY indicator is lit, the power turns ON when you press
the POWER RCVR key on the remote control. When the power comes
ON, press the key you want to operate.
Operating range
(Approx.)
6 m
POWER RCVR
• When pressing more than one remote control key successively, press
the keys securely by leaving an interval of 1 second or more between
keys.
Notes
1. The supplied batteries may have shorter lives than ordinary batteries
due to use during operation checks.
2. When the remote-controllable distance gets shorter than before,
replace both batteries with new ones.
3. Placing the remote sensor in direct sunlight, or in direct light from a
high frequency fluorescent lamp may cause malfunction.
In such a case, change the location of the system installation to prevent
malfunction.
2 Insert the batteries.
Remote sensor
Infrared ray system