Advertisement
3. From under vehicle, work header up on to bolt.
Install remaining header bolts and washers.
4. Re-install engine support bracket and engine
mount.
5. Lower engine and install engine mount bolt.
6. Install oil pressure sensor.
7. Re-install steering coupler shaft.
8. Slide steering rack back into location and re-install
and torque steering rack bolts to factory
specifications.
Right Side
1. Install one header bolt, lock washer, and hardened
washer with port gasket into front bolt hole on right
side of engine.
2. Working header up from under vehicle slip on to
bolt installed in Step 1. Install remaining bolts, and
washers.
3. Tighten header bolts from the center out.
4. Install spark plugs and wires.
5. Install starter.
6. Install alternator and support bracket.
Qty.
Part #
❑ 2
24-9716 A.I.R. Adapters
❑ 11 36-0710 Header Bolts
❑ 1
36-2860 C/B Bolt 3/8 - 16 x 2-1/4" (for port flange)
❑ 2
52-9710 O2 Sensor Bungs
❑ 2
54-6590 Port Flange Gaskets
❑ 3
56-6569 Heat Sleeves
❑ 4
60-8541 Hex Nut; 5/16"
❑ 4
68-6550 Hex Cap Screw; 5/16"
❑ 2
78-2004 Tie Wraps
©2007 Edelbrock Corporation
Catalog #65903
#22-6590 - Installation Kit
Description
Edelbrock Corporation, 2700 California St., Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Office: 310-781-2222
E-Mail: Edelbrock@Edelbrock.com
Qty.
Part #
❑ 1
25-9808
❑ 1
25-9809
❑ 2
25-9222
❑ 1
25-9814
❑ 1
25-9815
❑ 1
22-6590
Qty.
Part #
❑ 1
79-9534
❑ 2
79-9749
❑ 8
79-9750
❑ 1
79-9841
❑ 2
79-9842
❑ 1
79-9888
❑ 8
82-3600
❑ 12
82-5590
❑ 12
82-7231
Page 2 of 2
KIT CONTENTS
Description
Header, Left Side
Header, Right Side
Merge Collector
Collector Extension (Left)
Collector Extension (Right)
Installation Kit
Description
Spacer Tube
Evac. Tubes
Collector Tabs
A.I.R. Sub-Assembly
A.I.R. Sub-Assembly
EGR Sub-Assembly
Washer (AN); 5/16"
Lock Washers; 3/8"
Hardened Washers; 3/8"
Rev. 8/07
Advertisement
