Table of Contents
Advertisement
Installation
■ Removing the Unit
1
Refer to the section "Removing the hard rubber frame" and then
remove the hard rubber frame.
Remove the screw (M4 × 8) on the back panel.
2
3
Insert the two removal tools deeply into the slots on each side,
as shown.
Screw (M4X8)
(commercially
available)
4
Lower the removal tool
toward the bottom, and pull
out the unit halfway while
pressing towards the inside.
Be careful to avoid injury from
the catch pins on the removal
tool.
5
Pull the unit all the way out
with your hands, being
careful not to drop it.
Accessory2
Removal tool
— 24 —
Advertisement
Table of Contents
