Advertisement
6.
Drill or grind off rivet heads (Figure 2) and
disassemble bracket.
bushing from bracket assembly.
7.
Install inner bracket onto transmission.
8.
Place the new torque arm under vehicle
and onto rear end with factory bolts and
washers.
Use supplied washers between
rear end housing and torque arm bracket,
only
if
needed.
compound. Leave bolt loose at this time.
9.
Grease inside of new polyurethane bushing
with supplied grease, and install onto
torque arm with part number on bushing
facing rear of vehicle.
bracket.
10. Install outer bracket and tighten at this
time.
11. Torque rear bolts to 97 ft./lbs.
12. After
driving
approximately
re-torque all bolts and check on regular
basis.
NOTE:
To further upgrade your suspension, use other Edelbrock suspension, components, such as: springs,
shocks, trailing arms, panhard rod, strut tower brace, and sub-frame connectors.
Edelbrock Corporation, 2700 California Street, Torrance, California 90503
2001 Edelbrock Corporation
Remove O.E.M.
Use
thread-locking
Position in inner
10
miles,
Toll-Free Tech Line (800) 416-8628
Tech E-mail: edelbrock@edelbrock.com
Outer Bracket
Rivet
Rivet
Inner Bracket
Rivet
Inner/Outer Bracket
Fig. 2
Revised 7/01 (R&D)
Rivet
Advertisement
