Advertisement
96-005605-030-000_E2115 QSG_R0.qxd
Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base to charge for 15 hours before use. You can keep the batteries
charged by returning the handset to the base after each use. When batteries are fully
depleted, a recharge takes about 10 hours.Average talk time on a fully charged battery is
about six hours depending on environmental conditions, standby time is approximately
four days.
Press coin into slot on
base of handset to
release latch, then
remove battery cover.
Insert top
tabs first
Caution: Use only supplied rechargeable battery or AT&T
replacement battery model 2419/2420 (SKU 00578).
12/20/2004
10:03 AM
Plug power cord
transformer into
electrical outlet.
Insert supplied
battery
Place handset in base to charge for 15 hours
before first use.
Press down to
click in place
Page 2
Plug telephone line cord into
telephone jack.
Advertisement
