Dell PowerEdge 6300 Replacement Manual page 2

Replacing dell poweredge 6300 and 4300 system power supplies

Hide thumbs Also See for PowerEdge 6300:

handle release

cable strain-

relief clips (3)

power supply handle

(must be completely

open to insert the

power supply)

power supply

Rotate the power supply handle to the closed position.

As you rotate the handle, pivot levers on the handle hinge engage into slots in the

chassis and push the power supply into the chassis. If the power supply does not

slide into the chassis, reposition the power supply and ensure that the power

supply handle is completely open before you try rotating the handle again.

With the power supply fully inserted into the chassis, push in on the handle until

the handle latches into place.

NOTE: The power supply will not function until the latch is engaged.

Connect the AC power cable to the power supply and route the cable through the

cable strain-relief clips on the power supply handle.

Connect the AC power cable to the power outlet.

latch

Poweredge 4300