Sony SU-XWQ005 Owner's Manual page 11

3
Install the Display Unit on the
Plate Unit.
1 Insert the screws (M6 L20, supplied) into
the screw holes on the outer left and right
sides of the Mounting Hook Unit support
shafts, and tighten them temporarily.
Mounting Hook Unit
Support Shaft
Note
If the temporarily attached screws protrude inside the
Mounting Hook Unit support shafts, they will get in
the way of Mounting Hook Units being fitted in place
(procedure 4).
2 Attach the upper hooks of the two Mounting
Hook Units to the support shafts of the arms.
3 Place the lower hooks of the two Mounting
Hook Units so that they touch the front side
of the Mounting Hook Unit support shafts.
4 Slightly push the Display Unit toward the
Plate Unit and upward to attach the lower
hooks of the two Mounting Hook Units to the
Mounting Hook Unit support shafts.
2
4
3
Tighten the
screws to halfway
so that they do
not protrude from
the opposite side.
Mounting Hook Unit
5 Confirm the eight hooks are firmly hooked
on the four shafts on the Plate Unit.
6 Firmly tighten the securing screws that you
screwed in temporarily in Procedure 1.
Confirm the completion
of the installation
Check the following points.
• Eight hooks of the Mounting Hook Units are
firmly hooked on to the four shafts on the
Plate Unit.
• The cord and the cable are not twisted or
pinched.
• The two securing screws are securely
tightened on the Mounting Hook Unit.
WARNING
Incomplete installation may cause the product to
fall and result in injury or product damage. Also,
improper placement of the AC power cord, etc.,
may cause fire or electric shock through a short
circuit.
Be sure to confirm the completion of the
installation for safety.
US
9
(US)