Advertisement
NOTICE
The power supply for
this appliance is
220-240V, 50Hz
Single phase.
It is not
recommended
to use extension
cords.
Connect the appliance to a properly
earthed three pin socket.
SETTING UP
The fridge cannot be installed with its
rear panel directly against the wall. For
good air circulation, there should be a
gap of 100mm. Install the machine on a
flat and firm ground to minimize noise.
Never store anything dangerous
in this unit, such as
combustibles, explosives,
strong
acid,
or alkali etc.
Avoid installing the appliance
in rooms where it is poorly
ventilated,in direct exposure
sunlight or other similar
sources of heat.
2
LAMP
Lamp: 220-240V,15W
Lamp holder: E14 (lamps exceeding 15W must not be used).
When replacing the lamp:
LAMP
REPLACEMENT
To replace the lamp:
* Unplug the appliance and remove the
water tray from under the ice box.
* Press on the front of the lamp cover
while pulling it down to release it from
the lamp holder.
* To remove the lamp, turn it anti-
clockwise.
* Replace the lamp and cover then refit
the water tray.
WIRING DIAGRAM
7
Advertisement
