Table of Contents
Advertisement
Table 1
Type
EMI/EMC
Post Telephone & Telegraph
(PTT)
USA
FCC Part 15 Notice
Cisco 2600, 3600, and 3700 series routers comply with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
1.
2.
Modifying this equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A or Class B digital devices. In that event, your right to use
the equipment may be limited by FCC regulations, and you may be required to correct any interference
to radio or television communications at your own expense.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
Compliance with FCC Part 68 Requirements
This equipment complies with Part 68 of the FCC rules. On the bottom of the chassis is a label that
contains, among other information, the FCC registration number and ringer equivalence number (REN)
for this equipment. If requested, this information must be provided to the telephone company.
OL-10259-02
Agency Compliance
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety Information
Compliance
Emissions:
47CFR15 Class A (FCC); CISPR22 Class A; EN55022 Class A;
AS/NZS 3548 Class A (ACA); ICES003 Class A (Industry Canada);
V-3 Class A (VCCI); CNS13438 Class A (BSMI); EN61000-3-2;
EN61000-3-3; EN300386 Class A
Immunity:
EN50024, EN50082-1, & EN61000-6-1 (including EN 61000 4-2
Electrostatic Discharge; EN 61000 4-3 Radiated Susceptibility; EN
61000 4-4 Electrical Fast Transients; EN 61000 4-5 Power & Signal
Line Surges; EN 61000 4-6 Injected RF Swept Immunity;
EN61000-4-11 Voltage Dips + Sags); EN300386
This equipment complies with all the regulatory requirements for
connection to the communications networks of each country in which
it is sold.
Agency Compliance
3
Advertisement
Table of Contents
