Signal Strength Affecting Cellular Transmissions; Troubleshooting - Nokia 8850 - Cell Phone - GSM Installation Manual

3.4 SIGNAL STRENGTH AFFECTING CELLULAR TRANSMISSIONS

When you are sending a fax, data, or an SMS message, you need to be in an area with
network coverage. Cellular connections can be made from most locations where your mobile
phone operates.
Cellular networks differ from landline networks in many ways, for example, traffic loads and
the strength of radio signals may vary in a cellular network and cause handovers.
lt is recommended that you move the phone to a location where the strongest possible
cellular signal can be obtained. When the signal is strong, cellular transmission is efficient.
4.

TROUBLESHOOTING

Read the README file included in the Windows Program Group of the PC Suite for Nokia
8850.
This chapter points out the basic problems that could occur when you are installing the
program. Below you will find a list of symptoms and possible actions you can take if you are
in any of the following situations.
Setup will not run properly and returns an Error Message stating that the operating
system is not appropriate.
The PC Suite for Nokia 8850 is only compatible with Windows 2000/XP.
The Setup program does not start properly or is not completed.
It is recommended that you have 8 MB of RAM in your system, and at least 9 MB of free disk
space.
Close all unnecessary Windows programs before starting Setup. Also make sure that there
are no MS-DOS programs running in the Windows DOS Prompt.
Not enough disk space for installation.
There is not enough space for completing the installation on the drive you have selected.
Select another drive for installation or delete unnecessary files to free additional disk space.
lf you have several hard disk drives in your system and you decide to install the program on
a drive other than the one where your Windows system files are located, disk space is still
required on both drives. The program will always need to place some files in your Windows
directory.
Setup does not accept the destination directory you have typed in.
The program can only be installed to a local drive.
Check if the directory where you are trying to install the program is a READ ONLY directory.
Select another directory or change the settings of the directory in Explorer (File/Properties -
Attributes Window - Read Only setting).
7/9