Restricting Wireless Access By Mac Address - NETGEAR WNR1000-2VCNAS User Manual

To connect both non-WPS-enabled and WPS-enabled clients to the WNR1000v2 router:
1. Configure the settings of the WNR1000v2 router (shown in the Wireless Settings screen) for
WPA-PSK or WPA2-PSK security, and record that information. See
and WPA2-PSK Wireless Security" on page
When you change security settings, all existing connected wireless clients that do not share
those settings are disassociated and disconnected from the router.
2. For the non-WPS-enabled devices that you wish to connect, open the networking utility, and
follow the utility's instructions to enter security settings.
3. For the WPS-enabled devices that you wish to connect, follow the procedures in
'N' Connect (Wi-Fi Protected Setup)" on page
The WNR1000v2 router automatically preserves the settings you configured in
clients share the same security settings (for more information, see
Settings" on page
4. For information about how to view a list of all devices connected to your router (including
wireless and Ethernet connected), see

Restricting Wireless Access by MAC Address

When a Wireless Card Access List is configured and enabled, the router checks the MAC address
of any wireless device attempting a connection and allows only connections to computers
identified on the trusted computers list.
The Wireless Card Access List displays a list of wireless computers that you allow to connect to
the router based on their MAC addresses. These wireless computers must also have the correct
SSID and wireless security settings to access the wireless router.
The MAC address is a network device's unique 12-character physical address, containing the
hexadecimal characters 0–9, a–f, or A–F only, and separated by colons (for example,
00:09:AB:CD:EF:01). It can usually be found on the bottom of the wireless card or network
interface device. If you do not have access to the physical label, you can display the MAC address
using the network configuration utilities of the computer. In WindowsXP, for example, typing the
command in an MSDOS command prompt window displays the MAC address as
ipconfig/all
Physical Address. You might also find the MAC addresses in the router's Attached Devices
screen.
To restrict access based on MAC addresses:
1. Select Wireless Settings under Advanced in the main menu.
Safeguarding Your Network
2-16).
"Viewing a List of Attached Devices" on page
v1.0, November 2009
Wireless-N 150 Router WNR1000v2 User Manual
2-10.
2-13.
"Configuring WPA-PSK
"Using Push
step 1 so all
"Configuring the WPS
6-7.
2-18