Viewing Your Ota Channels; Connecting To Atv Using The Channel 3-4 Output - EchoStar Over-the-Air Module MT2 User Manual

6. Select a channel and then select Edit Name to change the way the
channel name displays in the Program Guide and other channel
lists. You can rename only one channel at a time.
7. Use the on-screen keyboard to enter the channel name.
Select Done when you are finished making changes.
8.

Viewing Your OTA Channels

The over-the-air channels that are scanned into the receiver using the
previous steps can be viewed in the on-screen Program Guide below
channel 100. The OTA channels are listed in yellow in the Program
Guide.
Note : You will need to have satellite signal and subscribe to DISH
Network programming to view channels received using the OTA
Module. Guide information for over-the-air channels displays only if
you are subscribed to DISH Network local channels.
C
ONNECTING TO A
C
HANNEL
Use the C 3-4 O
H
cable. The TV connected to the Channel 3-4 output views the same
programming as your TV1 viewing location. Refer to your receiver
User's Guide for more details on the TV1 viewing location.
1. Install the module into the receiver using the instructions on page 3.
2. Connect one end of a coax cable to the C
the module.
3. Connect the other end of the coax cable to a coax connection on
your TV. This connect may be labeled A
3-4 O
UTPUT
connection to connect to a nearby TV using coax
UT
TV U
SING THE
H
NTENNA
3-4 O connection of
UT
I , C
N ABLE
I , or a
N
Page 7