Carton Contents - Craftsman 79481 - Professional 28cc 2 Cycle Gas Blower Operator's Manual

CARTON C ONTENTS
Check carton c ontents against the fol-
lowing list.
Model 358,794810
• Blower
• Blower tube
• Standard nozzle
• High velocity nozzle
• 2-cycle engine oil
Your blower can also be used as a
vacuum by purchasing an optional
vacuum kit (#71-79976), Contact
your Sears Service Center for de-
tails.
NOTE: It is normal for the fuel filter to
rattle in the empty fuel tank.
ASSEMBLY
_WARNING: Stop engine and be
sure the impeller blades have stopped
turning before opening the vacuum in-
let door or attempting to insert or re-
move the vacuum tubes. The rotating
blades can cause serious injury.
,l_ WARNING: If you receive your
unit assembled, repeat all steps to en-
sure your unit is properly assembled
and all fasteners are secure.
BLOWER TUBE ASSEMBLY
1. Remove tube clamp bolt and knob
by turning counterclockwise.
Tube Clamp Bolt _
and Knob \ / %_
2,
Align the rib on the blower tube with
the groove in the blower outlet; insert
the tube until the holes in the tube
and housing line up.
Blower Outlet
Groove
Rib
3. Secure the tube by re-installing the
tube clamp bolt and knob; turn
clockwise to tighten.
4. Align the slots on the nozzle with the
tabs on the blower tube.
NOTE: When greater accuracy and
high air stream concentration is
desired, use the standard nozzle.
When a wider air stream and greater
air velocity is desired, use the high-
velocity nozzle.
Blower Tube
_--_- -"_ f_, Standard Nozzle
Slot. High Velocity Nozzle
5. Slide the nozzle onto the blower
tube.
6. Turn the nozzle clockwise until a
click is felt to secure the nozzle to
the blower tube.
NOTE: The length of the blower tube
can be adjusted by turning the nozzle
counterclockwise to loosen and sliding
the nozzle to the desired position. Turn
the nozzle clockwise to secure.
7. To remove the tube and nozzle,
remove the tube clamp bolt and
knob by turning counterclockwise;
remove the tube and nozzle.
-6-