Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual page 73

Appendix A Launching Fabric Manager in Cisco SAN-OS Releases Prior to 3.2(1)
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Note
Click Discover.
Step 9
You see the Open Fabric dialog box shown in
Figure A-3
Check the check box(es) next to the fabric(s) you want to open in the Select column, or click the
Step 10
Discover button to add a new fabric.
Note
Note
Click Open to open the fabric.
Step 11
Setting the Seed Switch in Releases Prior to Cisco SAN-OS
Release 3.1(1)
Note As of Cisco SAN-OS Release 3.1(1), the Fabric Manager login procedure changed. If you are running
Cisco SAN-OS Releases 3.1(1) to 3.2(1), then follow the login instructions in the
Switch in Cisco SAN-OS Releases 3.1(1) to 3.2(1)" section on page
OL-7765-05
The Accelerate Discovery check box should remain checked for normal operation. Uncheck this
only if you have changed switch IP addresses. You may experience problems with SAN IDs in
Fabric Manager if you uncheck this check box.
Open Fabric Dialog Box
As of Cisco SAN-OS Release 3.1(1) and later, opening multiple fabrics is a licensed feature. You
will get an error message if you open more than one unlicensed fabric.
As of Cisco SAN-OS Release 3.1(2b), a license can be a permanent license, an evaluation
license, or there are no licenses (all evaluation licenses have expired).
Setting the Seed Switch in Releases Prior to Cisco SAN-OS Release 3.1(1)
Figure A-3.
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
"Setting the Seed
A-1.
A-3