Creating Zone Sets - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 6 Configuring Zones and Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To create zone sets, follow these steps:
Click Zone > Edit Local Full Zone Database from the Zone menu or right-click a VSAN folder in the
Step 1
Logical tab and choose Edit Local Full Zone Database from the pop-up menu.
Select a VSAN and click OK.
Step 2
You see the VSAN you selected in the Edit Local Full Zone Database window.
Right-click the Zonesets folder in the Edit Local Full Zone Database dialog box for that VSAN and
Step 3
select Insert to add a zone set (see
Figure 6-6
Step 4 Assign a name to the new zone set.
In the left pane, drag and drop zones into the zone set.
Step 5
After creating a zone set, you must activate it to take effect. Click a zone set to activate it or right-click
Step 6
the zone set and select Activate. This configuration is distributed to the other switches in the network
fabric.
Note
You see a dialog box that shows whether the zone set activation or deactivation was successful (see
Figure
OL-7765-05
Insert a new zone set
When you confirm the activate operation, the current running configuration is saved to the
startup configuration. This permanently saves any changes made to the running configuration
(not just zoning changes).
6-7).
Figure 6-6).
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide

Creating Zone Sets

6-5