EAW UX8800 Owner's Manual page 18

4.4.6
PC
Ethernet
Hub or Switch
EAWPILOT
4.4.7
Ethernet Hub or Switch
PC
Ethernet
EAWPILOT
UX8800 "A"
U-Net
1
Ethernet
UX8800 "C"
U-Net
1
4.4.8
EAWPilot requires an IBM compatible PC equipped as follows:
The latest EAWPilot can be downloaded from the EAW web site: www.eaw.com. Go to the "Downloads"
page or contact the factory and a copy will be sent to you on a CD-ROM. Once installed and with the
computer connected to the UX8800, open EAWPilot by clicking on EAWPilot in the
Start/Programs/EAW/EAWPilot.
CONNECTING MULTIPLE PROCESSORS TO AN ETHERNET NETWORK
To additional
UX8800(s)
Ethernet
UX8800 "A"
U-Net U-Net
1 2
CONNECTING MULTIPLE PROCESSORS TO AN ETHERNET AND U-NET NETWORK
Ethernet
UX8800 "B"
U-Net
U-Net
2 1
Ethernet
UX8800 "D"
U-Net U-Net
2 1
SOFTWARE INSTALLATION -- EAWPILOT
Operating System:
I/O:
Use the front panel Ethernet port and a standard Ethernet cable to
connect each processor to a 10, 10/100, or 100 Mbps Ethernet hub,
switch, or router on a network.
Use the front panel Ethernet port and a standard Ethernet
cable to connect processors to a 10, 10/100, or 100 Mbps
Ethernet hub, switch, or router on the network. Connect
additional processors to the Ethernet hub, switch, or
router or connect additional processors to the system
using the U-Net ports as in Section 4.4.4.
U-Net
NOTE: Audio signals may also be routed between
2
processors over the same U-Net cables by assigning
Input Channel and Output Channel signals to U-Net
channels.
U-Net
2
Windows Vista, XP, 2000, NT, ME, or Windows 98
Ethernet network interface card (NIC) 10, 10/100, or 100 Mbps
Page 8