Maxtor OneTouch II User Manual page 10

Step 2. Connect the Drive
The Maxtor OneTouch II Small Business Edition drive connects to
your computer using a USB interface. Make sure you know where
the USB interface is located on your computer.
2
Please Install the software BEFORE you connect
the drive.
Connecting the Power
1. Plug the round female connector from the power adapter into
the drive's power connector.
2. Plug the two-pin female connector on the power cord
into the power adapter.
Figure 3. Connecting the Power
3. Plug the standard electrical plug from the power adapter into
your power source.
4. Turn on the Maxtor OneTouch II Small Business Edition drive
using the power switch on the back of the drive. The two blue
lights on the front should illuminate.
8
Connecting the USB Cable
To connect the USB cable
1. Plug the flat end of the USB cable into any available USB port
on your computer. This USB logo
identify a USB port.
2. Plug the square end of the USB cable into the USB connection
on the drive.
USB Port
Figure 4. Connecting a USB Port
It may take up to 2 minutes for your computer to recognize
the drive, after connecting it to your computer.
A 'Found New Hardware' message will appear briefly at the
bottom of the screen once your drive is recognized by your
computer.
3. If the Welcome to Maxtor OneTouch Setup screen is still
visible, click Cancel to close it.
may help you
™
USB Port