Download Print this page

Frigidaire FFDI331CMS Use & Care Manual

Complete owner's guide (english).
Hide thumbs

Advertisement

TROUBLESHOOTING
Before seeking repair or replacement, we recommend that you review the following:
LOUD NOISES:
(Other than those during grinding of
small bones and fruit pits): These are usually caused by
accidental entry of a spoon, bottle cap or other foreign
object. To correct this, turn off electrical switch and water.
After disposer has stopped, remove *splash guard, remove
object with long handled tongs, and replace *splash guard.
UNIT DOES NOT START:
either the wall switch or breaker box switch to "OFF"
position, depending on your model and wiring configuration.
Remove stopper and/or *splash guard. Check to see if
turntable will rotate freely using a wooden broom handle. If
turntable rotates freely, replace *splash guard and check re-
set button to see if it has been tripped. Re-set button is red
and located opposite discharge elbow, near the bottom (see
8A). Push button in until it clicks and remains depressed.
If re-set button has not been tripped, check for shorted or
broken wire connecting to disposer. Check electrical power
switch, fuse box or circuit breaker. If wiring and electrical
components are intact, the unit may have internal problems
that require service or replacement.
*Splash guard not used on Top Control/Batch Feed unit.
Call our toll free Help Line with any questions
CLEANING AND MAINTENANCE
The motor is permanently lubricated. The disposer is self
cleaning and scours its internal parts with each use.
NEVER put lye or chemical drain cleaners into the disposer,
as they cause serious corrosion of metal parts. If used,
resulting damage can be easily detected an all warranties
are void.
8
Unplug power cord or turn
800-944-9044
DO NOT ATTEMPT TO LUBRICATE YOUR DISPOSER!
IF TURNTABLE DOES NOT ROTATE FREELY:
Turn off disposer, then check for any foreign object lodged
between the turntable and grind ring. Dislodge object by
rotating table with a wooden broom handle and remove
object. (see 8B) If no foreign object is present, there may
be internal problems.
LEAKS:
If the unit leaks at the top, it may be due to:
1. Improper seating of sink flange (gasket centering, putty
or tightening).
2. Support ring not tightened properly.
3. Defective or improperly installed cushion mount.
If unit leaks at the waste elbow, leak may be due to im-
proper tightening of elbow flange screws.
8A
Mineral deposits from your water can form on the stainless
steel turntable, giving the appearance of rust. DO NOT BE
ALARMED, the stainless steel turntables used will not
corrode.
8B
560C525P02 REV A

Advertisement

   Also See for Frigidaire FFDI331CMS

   Summary of Contents for Frigidaire FFDI331CMS

  • Page 1: Troubleshooting

    TROUBLESHOOTING Before seeking repair or replacement, we recommend that you review the following: LOUD NOISES: IF TURNTABLE DOES NOT ROTATE FREELY: (Other than those during grinding of small bones and fruit pits): These are usually caused by Turn off disposer, then check for any foreign object lodged accidental entry of a spoon, bottle cap or other foreign between the turntable and grind ring.

  • Page 2: Table Of Contents

    Electrical Connections ........6 Important Safety Instructions ......2 Operating Instructions ........7 Removal of Old Unit ........... 3 Troubleshooting ..........8 Installation of Mounting Assembly ....4 - 5 Cleaning and Maintenance ........8 www.frigidaire.com USA 1-800-944-9044 www.frigidaire.ca Canada 1-800-265-8352...

  • Page 3: Product Registration

    PRODUCT REGISTRATION Bill of sale, sales slip, cancelled check or other purchase See insert for specific information about your new record should be kept to verify the original purchase date for disposer: warranty purposes. NOTE: This Food Waste Disposer has been designed to operate on 110-120 Volt, 60Hz exclusively.

  • Page 4: Removal Of Old Unit

    REMOVAL OF OLD UNIT TYPICAL INSTRUCTIONS, YOUR MODEL MAY VARY Caution: Be sure to support the disposer while Before starting this step, turn off electrical power perfomring this step or it may fall when the at the circuit breaker or fuse box. mounting ring is disconnected from the mounting If your old mount is the same as the mount on your new assembly.

  • Page 5: Installation Of Mounting Assembly

    INSTALLATION OF MOUNTING ASSEMBLY Rubber Gasket Stopper Sink Flange Lower Mounting Ring Fiber Gasket Backup Flange Dishwasher Inlet Mounting Ring Disposer Hush Cushion® Snap Ring NOTE: Hush Cushion included between mounting ring and lower mounting ring. Mount System READ COMPLETELY BEFORE STARTING NOTE: Pay close attention to the order of mount assembly parts, as they have been correctly assembled by the factory.

  • Page 6

    INSTALLATION OF MOUNTING ASSEMBLY YOUR DISPOSER COMES WITH THE FOLLOWING MOUNT SYSTEM Mount System READ COMPLETELY BEFORE STARTING NOTE: Pay close attention to the order of mount assembly parts, as they have been correctly assembled by the factory. D. Place a weight such as a disposer on the sink flange to A.

  • Page 7: Electrical Connections

    ELECTRICAL CONNECTIONS Wiring Disposer Directly to House Current A. Connect disposer to 110-120 Volt, 60Hz AC current only. This appliance must be connected to a grounded, metal permanent wiring system or an equipment grounding con- B. If plug-in cord is used, use a three prong plub (see A). ductor must be run with the circuit conductors and connected Ground wire should be attached to the ground screw in to the equipment-grounding terminator or lead on the...

  • Page 8: Operating Instructions

    OPERATING INSTRUCTIONS The Anti-Jam Swivell Impellers make a clicking sound as they swing into place. This indicates normal operation. that the disposer slows down while grinding. The A. Remove sink stopper. Turn on a medium flow of cold disposer is actually increasing torque (grinding power) water.

This manual also for:

Ffdi331dms Ffdi501cms Ffdi501dms Ffdi502cms Ffdi502dms Fgdi753dms... Show all

Comments to this Manuals

Symbols: 0
Latest comments: