Dishwasher Specifications - Frigidaire FFBD2411NB Product Specifications

24" Built-In Dishwasher w/Ready-Select Controls (RSC)
Baseline

Dishwasher Specifications

• Product Shipping Weight (approx.) – 64 Lbs.
• Voltage Rating – 120V / 60 Hz / 15 Amps (maximum 20 Amps if
connected with disposer)
• Connected Load (kW Rating) @ 120 Volts = 1.44 kW
(For use on adequately wired 120V, dedicated circuit having 2-wire
service with a separate ground wire. Appliance must be grounded
for safe operation.)
• Amps @ 120V = 10 Amps
Always consult local and national electric & plumbing codes.
•
Meets requirements of ASSE 1006 — integral air gap on supply.
• Water Pressure – Hot water line to dishwasher must provide
between 20 and 120 pounds per square inch (psi).
• Make sure location has right drain, water and electrical outlets
to make connections.
USA 10200 David Taylor Drive Charlotte, NC 28262
• •
CANADA 5855 Terry Fox Way Mississauga, ON L5V 3E4
• •
FFBD2411N 03/12
1-800-FRIGIDAIRE frigidaire.com
• •
1-800-265-8352 frigidaire.ca
• •
© 2012 Electrolux Home Products, Inc.
FFBD2411N S / M / W/ B / Q
• Keep back free of drain, water & electrical supply.
• Electrical and water supplies should enter cabinet opening on floor,
or through back or side walls, as shown in shaded areas.
• Connections preferably located toward left side of dishwasher. Do not
cross drain, water or electrical lines in front of motor, blower or frame.
When installing adjacent to wall, cabinet or other obstruction that
•
extends beyond front edge of unit, allow 2" minimum clearance
between opened door and obstruction.
When installing at end of cabinet line, sides must be fully enclosed.
•
• Do not install unit under a cooktop, damage will occur.
Note: For planning purposes only. Refer to Product Installation Guide
on the web at frigidaire.com for detailed instructions.
Dishwashers
24" Built-In
Meets
requirements of
ASSE 1006
Specifications
subject to change.