Connecting Using Hdmi; Switching The Hdmi Audio Setting; Resetting The Hdmi Connection - Pioneer HTZ-360DV Operating Instructions Manual

Other connections

Connecting using HDMI

If you have a HDMI or DVI (with HDCP)
equipped monitor or display, you can connect
it to this player using a commercially available
HDMI cable for high quality digital video.
See About HDMI below for more about the
HDMI connection.
• Use an HDMI cable to connect the HDMI
OUT interconnect on this player to an HDMI
interconnect on a HDMI-compatible monitor.
HDMI
connector
C /
ANTENNA
R
P
COMPONENT R
VIDEO
C /
B
VIDEO
P
B
FM
UNBAL 75 Ω
AM LOOP
S-VIDEO Y
VIDEO OUT
HDMI OUT
HDMI OUT
• The arrow on the cable connector body
should be face up for correct alignment
with the connector on the player.
You can also adjust the HDMI settings for
resolution and color. For more on these
settings see Video Output settings on page 26.
Note
1 • An HDMI connection can only be made with DVI-equipped components compatible with both DVI and High Bandwidth Dig-
ital Content Protection (HDCP). If you choose to connect to a DVI connector, you will need a separate adaptor (DVI
do so. A DVI connection, however, does not support audio signals. Consult your local audio dealer for more information.
• This unit has been designed to be compliant with HDMI (High Definition Multimedia Interface) Version 1.1. Depending on
the component you have connected, using a DVI connection may result in unreliable signal transfers.
• When you change the component connected to the HDMI output, you will also need to change the HDMI settings to match
the new component (see Video Output settings on page 26 to do this).
1
HDMI-compatible display
FRONT R L CENTER
LINE
L
R
SUB
R L
SURROUND WOOFER
AUDIO IN
SPEAKERS

Switching the HDMI audio setting

To listen to audio from the HDMI interconnect,
make sure you've specified the HDMI audio
output setting.
1 Switch the system into standby.
2 Press SETUP and use
HDMI OUT then press ENTER .
3 Use to choose the setting you want
then press ENTER .
• AUDIO ON – Audio signals are output
through the HDMI interconnect
• AUDIO OFF – Switches off HDMI audio

Resetting the HDMI connection

If you get an error message (the display shows
HDMI ERR) or if the screen goes blank (for
example, after changing the resolution), check
the troubleshooting guide on page 42. If this
doesn't solve the problem, follow the steps
below to reset the HDMI connection.
1 Switch the system into standby.
2 Press SETUP and use
HDMI INI then press ENTER .
The system will restart and the HDMI settings
are automatically reset to the factory defaults.
See Video Output settings on page 26 for more
on these settings.
08
to choose
to choose
HDMI) to
33
En