Sony NWS706FB Operation Manual page 98



Troubleshooting...
Message
UPDATE ERROR
USB CONNECT
USE ORIGINAL HEADPHONE
(NW-S703F/S705F/S706F only)
To delete abnormal data from the built-in flash memory
If "CANNOT PLAY, " "DRM ERROR, " "EXPIRED, " "FILE ERROR, " "FORMAT
ERROR, " "MEMORY ERROR, " or "NO DATABASE" appears, there is a problem
with all or part of the data stored in the built-in flash memory.
Please follow the procedure below to erase data you cannot play.
1
Connect the player to the computer, and start SonicStage.
2
If you have already specified the data with problems, erase the data
using SonicStage.
3
If the problem persists, transfer all data without problems back to the
computer using SonicStage while the player is connected to the
computer.
4
Disconnect the player from the computer and then format the built-in
flash memory using the "Format" menu (  page 57).
Messages
Meaning
The player fails to update
the firmware.
The player is connected to
a computer.
The following functions
were used when the
headphones
corresponding to the
Noise Canceling function
were not connected.
 Noise Canceling ( 
page 28)
 Noise Cancel Control
setting (  page 38)
Remedy
Follow the on-screen
instructions on the
computer and update
again.
This is not a malfunction.
You can operate the player
using SonicStage, but you
cannot operate the
controls on the player.
Connect the supplied
headphones or headphones
corresponding to the Noise
Canceling functions.