Advertisement
INSTALLATION
1 Turn OFF the computer's power and remove the power cord from the wall outlet
before removing the front panel cover.
2 Remove the blank panel from the front of the 5.25" bay slot.
3 Install the fixing slide rails on the drive. (When slide rails are required, please contact
the store where the drive was purchased.)
4 Insert the drive into the slot.
5 When anchoring is required, please refer to the computer's instruction manual.
÷ Please use screws measuring 5mm (3/16 in.) or less for mounting. Using
longer screws may damage the drive.
÷ When the mounting screws are loose, the vibrations from a spinning disc may
generate ripping noise. To prevent this noise, tighten the screws.
9
En
Advertisement
