Frigidaire FFBD2403LB Service Data Sheet page 2

Color Code
BK......................... Black
BU............................Blue
PK............................Pink
R...............................Red
R-BK...............Red/Black
R-Y................Red/Yellow
VIO.........................Violet
W...........................White
The water/service test is a special function
initiated from the power failure mode or idle
mode.
While in power failure mode - simultaneously
press the HI-TEMP WASH and START/CANCEL
pads for second.
The dishwasher will then step through the test
cycle per the chart. Pushing the START/CANCEL
pad will advance the dishwasher to the next step.
While in idle mode - simultaneously press the HI
TEMP and START/CANCEL pads for 3 seconds.
POTS & PANS /
HEAVY WASH *
NORMAL WASH
ECO/ LIGHT WASH
UPPER RACK *
RINSE ONLY
WASHING
SANITIZED*
DRYING
CLEAN
TIME
WASH 1 RINSE 1
IN
8 MIN. 10 MIN.
MINUTES
WATER VALVE
DRY SYSTEM *
PUMP MOTOR
DRAIN MOTOR
HEATER
DISPENSERS
* SOME MODELS
Operation
To start Close and latch door. Press START/CANCEL pad.
To delay start Close and latch door. Press DELAY START pad to select desired
delay time.
To select a new
Press desired cycle and/or option pad. The indicator lights will change. Press
cycle or option
START/CANCEL within 15 seconds to begin cycle.
To cancel cycle Press START/CANCEL. Dishwasher will drain for 90 seconds, then shut off.
Water/Service Test
1 FILL/DISPENSER 60 1 0 0 0 1
2 FILL 27 1 0 0 0 0
45 0 1 0 0 0
3 WASH
0.4
4 PAUSE 0 0 0 1 0
5 WASH/HEAT 75 0 1 0 1 0
6 WASH/HEAT/DISP. 60 0 1 0 1 1
7 DRAIN 90 0 0 1 0 0
8 90
DRY 0 0 1 X 0
TOTAL 488
X - denotes selectable option
CLEAN LED stays on until door is opened or cycle is started.
RINSE 2 WASH 2
10 MIN. 21 MIN.
WARNING
Disconnect electrical power at the fuse box
or circuit breaker box before servicing under
this product. Electrical power may be
present on some parts under this product,
even if not in use.
Failure to follow this warning could result in
serious injury or death.
1 0 0 0
1
1 1 0 0 0
1 0 0 0
1
1 0 0 0
1
1 0 0 0 0
1 0 0 0 0
1 0 0 0 0
0 0 0 1 0
0 1 0 1
Cycle Selection Options
RINSE 3
10 MIN.
WATER HEAT DELAY
Display Codes (LED)
WASHING ---------------------- Wash portion of cycle.
SANITIZED -------------------- The SANITIZED criteria has been met. Indicator light will switch off when door is opened.
DRYING ------------------------ Drying portion of cycle.
CLEAN ------------------------ Shows completion of cycle. Indicator light will switch off when door is opened.
OPTION LED's Flashing ñ All LED's flashing indicates power failure has occurred. Press START/CANCEL pad and reselect desired options and cycle.
STATUS LED's Flashing -- The STATUS LED's that are lit when the door is opened will flash. Close door.
Wiring Diagram
RINSE 4 RINSE 5
10 MIN. 12.5 MIN.
WATER HEAT DELAY
DRY (HOT OR COOL)
23.5 MIN.