Asko D5220 Operating Instructions Manual page 22

Settings
Setting a signal
If you want the machine to signal when the wash is complete, you can program it to do this.
The machine is set without a signal by default.
the
ton.
PROG PROG
START
STOP
or Reset
PROG PROG
START
STOP
22
1. Switch off the dishwasher at the main switch.
2. Hold in the Delayed start button at the same time as you press
main switch. The button flashes. Release the but-
3. Press the Program button – when the Daily wash symbol lights,
the signal is activated.
4. Press the Start/Stop button and the setting will be stored until
next time you want to make a change.
1. Switch off the dishwasher with the main switch.
2. Hold in the Delayed start button at the same time as you press
the main switch. The button flashes. Release the button.
3. Press the Program button – when the Daily wash symbol goes
out, the signal is deactivated.
4. Press the Start/Stop button and the setting will be stored until
next time you want to make a change.
Customer Care Center
1-800-898-1879
www.askousa.com