Setting The I/O Control Options - Epson Endeavor Setup Manual

Setting the I/O Control Options

The I/O control options let you change the settings for the
following built-in interface ports:
You may need to change these settings if you install an
interface on an option card. The following table lists the
possible settings.
I/O control options
I/O control option
COM1 Select
COM2 Select
Parallel Port
Address
Setting
Enabled*
Disabled
Enabled*
Disabled
03BCH
0378H*
0278H
Disabled
Running the SETUP Program
Description
Enables the COM1 serial port
Disables the COM1 serial port
Enables the COM2 serial port
Disables the COM2 serial port
Sets the parallel port address to
03BCH
Sets the parallel port address to
0378H
Sets the parallel port address to
0278H
Disables the parallel port
2-19