JVC LM-150U - 15" LCD Monitor Instructions Manual page 11

The illustration of the monitor is of LM-170A.
8 INPUT SELECT buttons/lamps
Select an input to display.
VIDEO 1: Selects the video signal input to the
VIDEO 1 terminal.
VIDEO 2: Selects the video signal input to the
VIDEO 2 terminal.
DVI: Selects the video signal input to the DVI-
D terminal.
RGB: Selects the video signal input to the RGB
terminal.
• For LM-170A, the corresponding audio signal is
also selected.
9
STANDBY/ON button
Turns on and off (standby) the monitor.
NOTE:
• To disconnect the mains line completely, unplug the AC
plug from the wall outlet.
p Power lamp
Lights in orange:
The monitor is off (standby).
Flashes in orange:
The monitor is in the suspend mode.
Lights in Green:
The monitor is on.
Unlit:
The monitor is off (the AC plug is not
connected).
8 9
7 About the status display
When "STATUS DISPLAY" is set to "ON" (
16), the status (information of the current input
and the monitor settings) is displayed for about 5
seconds in the following cases:
• When you press the INPUT SELECT button of the
current input.
• When you change the inputs.
• When the signal condition of the current input
changes.
VIDEO 1
NTSC
OVER
1
Input status
2
Signal format
• "NO SYNC" is displayed when no video signal
is input.
• When "COLOR SYSTEM" is set to "AUTO"
( + page 13), "OTHERS" is displayed for a
noncompliant video signal input.
• "Out of range" is displayed for a noncompliant
computer signal input.
3
Setting of SCAN SIZE
+ "7 SCAN SIZE button/lamp" on page 8
NOTE:
• Not displayed for computer signals.
p
+
page
9