Table 7. Diagnostic Beep Codes
Beep
1
2
3
4
5
6
7
8
54
Description
BIOS ROM checksum in progress of
failure.
No RAM detected
•
Chipset Error (North and
South Bridge Chipset,
DMA/IMR/Timer Error)
•
Time-Of-Day Clock test failure
•
Gate A20 failure
•
Super I/O chip failure
•
Keyboard controller test
failure
RAM Read/Write failure
Real-time clock power fail
Video BIOS Test Failure
Processor Failure
Display
Possible Cause/Troubleshooting
Steps
System board failure, covers BIOS
corruption or ROM error
If no memory is detected, you can
perform the following steps:
•
reseat the memory if an
additional memory is available
•
install that memory if the
issue persists
•
issue with the memory
connector
System board failure
If no memory is detected, you can
perform the following steps:
•
reseat the memory if an
additional memory is available
•
install that memory if the
issue persists
•
issue with the memory
connector
CMOS battery failure. Reseat the
battery. If issue persists, there can be
an issue with the coin-cell battery or
the connector (that will involve
replacing the system board)
Video card failure
Processor failure
Display failure