Maytag MEDB700VQ - R BravosR Electric Dryer Use And Care Manual page 18

Check t helevelness ofthedryer byfirst p lacing a level onthetopofthedryer near t he
console.
Then, byplacing alevel i nthe crease ontheside ofthedryer between the topofthedryer and
thedryer cabinet, check thelevelness from front t oback.
3. I.oosen thetopscrew from each ofthe2hinges inStep 2 .
.A
B
A
B
If the dryer is not level, prop up the dryer using a wood block. Use a wrench to adjust the legs
up or down and check again for levelness.
You can change your door swing from a right-side opening to a left-side opening, if desired.
1. Place a towel or soft cloth on top of the dryer or work space to protect the surface.
Remove the door assembly
1. Open the dryer door.
2. Remove the bottom screw from each of the 2 hinges that attach the dryer door to the front
panel of the dryer.
A. Loosen these screws.
t:3. Remove these screws.
4. Remove the dryer door and the hinges by lifting upward on the door. I.ay the door on a
flat, protected surface, with the inside of the door facing up. Remove remaining 2 loose
screws from dryer front panel.
5. Remove the 4 plastic plugs located outside the dryer door opening.
6,
location of plastic
plugs shown
Install 4 plastic plugs into screw holes in the dryer left where the hinges were removed in
Step 4.
18