Speaker Components; Installing The Speakers On The Tallboy Stand - Samsung HT-E355 User Manual

Connections

Speaker Components

HT-E350
(L) (R)
FRONT
Speaker Components
HT-E355
(L) (R)
FRONT
STAND
(L) (R)
SURROUND
STAND BASE

Installing the Speakers on the Tallboy Stand

* HT-E355 - Front/Surround Speakers
1. Turn the Stand Base upside-down and connect it to the Stand.
2. Insert three screws (5*15, For connecting Stand & Stand Base) clockwise
into the three holes marked using a screwdriver as shown in the
illustration.
!
CAUTION : When you use a torque screwdriver, be careful not to put
excessive force. Otherwise, it runs idle or can be damaged. (torque
screwdriver- below 7 kg.f.cm)
3. Straighten a supplied speaker wire and put in the hole on the centre of
Stand Base.
4. Connect the upper Speaker to the assembled Stand.
5. Insert another large screw (5*15, For connecting Speaker & Stand)
clockwise into the hole on the rear of the speaker using a
screwdriver.
6. This is the appearance after the speaker is installed. Follow this
steps to install other speaker.
14
English
(L) (R)
SURROUND
SPEAKER CABLE
SCREW (5×15): 16EA

CENTER
SUBWOOFER
CENTER
Assembled Speakers
HT-E355
FRONT SURROUND
SPEAKER SPEAKER
1
Stand Base
Stand
3
5
SUBWOOFER
CENTER SPEAKER
SUBWOOFER
2
4
Speaker
Stand
6