Wireless Connection With Automatic Ip Address - Philips NP2500/37 User Manual

• A cable modem or PC with
broadband Internet access and a free
Ethernet port
• An Ethernet cable (sold separately).
• Wired (Ethernet) network connection
with static IP address
This setup requires the following:
• A cable modem or PC with
broadband Internet access and a free
Ethernet port
• An Ethernet cable (sold separately).
• Manual entry of your IP address.
Wireless connection with automatic
IP address
This is how to navigate and select with the
remote control:
• Press or to select a menu option.
• Press OK to confirm a selection.
• Press BACK to go back to the
previous screen.
HOME to go to the Home menu.
• Press
The alphanumeric buttons of the remote
control are multi-function buttons:
• To select a number or an alphanumeric
character, press a button once or
repeatedly until you see the number or
alphabetic character in the display of
NP2500.
• To cycle through the alphanumeric
characters that are available, press a
button repeatedly.
• To delete the last character entry from
the display, press CLEAR.
• To delete the whole last line entry
from the display, press and hold
CLEAR.
The onscreen display guides you
through the process of connecting
NP2500 to your home network and
the Internet. This section describes
the typical wireless setup with
automatic IP address. You can also
follow the onscreen prompts for
advanced configurations that are not
described in this manual.
1
Ensure that your network name and
network password or encryption key are
available.
2
Turn on your wireless access point or
wireless router with broadband Internet
access.
3
Turn on NP2500.
4
Press SETTINGS, to go to the Settings
menu.
5
Select [Wireless (WiFi)] to start the
network setup process.
• For wireless routers with Wi-Fi
protection system (WPS) that supports
push button configuration (PBC): On the
router, press the WPS PBC push button
to activate. On NP2500 press OK to
confirm.)
• For wireless routers with Wi-Fi
protection system (WPS) that supports a
personal identification number (PIN): On
NP2500 select WPS PIN, then enter the
displayed PIN on the router.
• For other wireless routers:
NP2500 searches for networks.
»
1
Select your network from the list of
found networks and confirm.
• Enter the encryption key (if required)
and confirm.
• NP2500 acquires the automatic IP
address.
• NP2500 shows the confirmation for
the connection to the network.
• NP2500 shows the prompt for the
connection to the Internet.
2
Select [Yes] to connect to the Internet.
NP2500 shows the confirmation for
»
the connection to the Internet.
Note
•
You can enter more than one encryption key.
In this case, NP2500 prompts you to select the
default encryption key.
EN
27