Philips 40PFL4907/F7 User Manual page 31

*You can set a particular about picture quality in Advanced picture.
Auto picture Color alignment
Backlight Noise reduction
Contrast Light sensor
Brightness Black stretch
Color Dynamic contrast
Tint Gamma
Sharpness MPEG artifact reduction Medium
Advanced picture Dynamic backlight
Mode
Red gain
Green gain
Color
alignment
Blue gain
Red offset
Green offset
Blue offset
Noise
to select the desired setting, then press OK
(Off, Minimum, Medium, Maximum and Auto)
reduction
Off
Light sensor
On
Black
to select the desired setting, then press OK
stretch (Off, Minimum, Medium and Maximum)
Dynamic
to select the desired setting, then press OK
contrast (Off, Minimum, Medium and Maximum)
Cursor ◄
Gamma
to adjust the gamma encoding of images
MPEG
to select the desired setting, then press OK
artifact
(Off, Minimum, Medium and Maximum)
reduction
to select the desired setting, then press OK
Dynamic backlight
(Off, Minimum, Medium and Maximum)
Off
Color
enhancement
On
Mode
Auto
On
Medium
Maximum
Maximum
to set the color temperature to
Personal, Cool, Normal and Warm
When you adjust the following
settings, Personal will be set
automatically.
Cursor ◄ Cursor ►
to decrease to increase
contrast with red contrast with red
to decrease to increase
contrast with contrast with
green green
to decrease to increase
contrast with blue contrast with blue
to decrease to increase
brightness with brightness with
red red
to decrease to increase
brightness with brightness with
green green
to decrease to increase
brightness with brightness with
blue blue
to set Light sensor to Off
to adjust backlight for the best picture
quality by dynamically adjusting the
backlight intensity in accordance with
lighting condition in the room
Cursor ►
to set color enhancement to Off
to make colors more vivid and bright
to select the desired setting, then press OK
(Red, Yellow, Green, Cyan, Blue and Magenta)
Tint
Custom
color
management
Saturation
Brightness
Off
Film mode
Auto
Note
• Mode selection is available only if
– the external Input modes are selected HDMI 1, HDMI 2 or HDMI 3.
– the connected HDMI device is outputting a video signal.
• Adjusts backlight for the best picture quality by dynamically adjusting the backlight
intensity in accordance with lighting condition in the room when Light sensor is set to
On. Please ensure the room lighting is stable and the light sensor is not blocked.
31
Cursor ◄ Cursor ►
to rotate
to rotate only
only selected
selected color
color tint in
tint in clockwise
counterclockwise
direction
direction
to decrease color to increase color
with only selected with only selected
color color
to decrease to increase
brightness with brightness with
only selected only selected
color color
to set film mode to Off
to optimize the picture recorded by
the original film
English