Troubleshooting - Panasonic DMC-FX90K Basic Owner's Manual

[Failed to connect wireless access point]/[Connection failed]/
[No destination found]
•
Check following regarding the wireless access point (broadband router).
> The wireless access point (broadband router) information set on this unit is
wrong. Check the authentication type, encryption type, and encryption key.
> Power of the wireless access point (broadband router) is not turned on.
> Setting of the wireless access point (broadband router) is not supported by
this unit.
•
Check the network setting of the destination.

Troubleshooting

First, try out the following procedures.
• "
Check Troubleshooting
format)".
If the problem is not resolved, it may be improved by selecting [Reset] on the
[Setup] menu when taking pictures.
Battery and power source
The camera cannot be operated even when it is turned on.
The camera turns off immediately after it is turned on.
•
The battery is exhausted. Charge the battery.
•
If you leave the camera on, the battery will be exhausted.
> Turn the camera off frequently by using the [Economy] etc.
Card/battery door does not close.
•
Insert the battery securely all the way in.
Recording
The picture cannot be recorded.
•
Is the mode set to [Rec] Mode?
•
Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available
memory.
•
You may not be able to record for a short while after turning the power [ON]
when using a large capacity card.
"
in the "Owner's Manual for advanced features (PDF
29
(ENG) VQT3S29